At a Glance:
- Eliminates "Bolt-Battering" of the receiver
- Eliminates vibration from metal to metal contact
- Easy drop in ready, no tools required
- Oil and solvent resistant
115 Reviews
-
Big Papa
Works great
-
awesome product
I didn't think I could reduce the recoil on my 10/22 (since there is hardly any to begin with) but this actually does the trick. Shoots noticeably softer and quieter. Mine was cut a little rough on either end, so install was tricky, but not bad. I'm going to order another one for a spare. Easily the best $5 you can spend on your rifle.
-
Quiet & smooth
Not much to add to the above reviews. It is a tight fit to the receiver holes, but a slight bevel from a belt sander to break the sharp edges takes care of that. It's a must have part.
-
Quieter.
This would not fit my 10/22 easily. I could only get it in a very short way. I put it in a drill motor and used sandpaper to get it to proper size. I did half, flipped it end for end in the drill and finished it up. It is snug and takes some effort to remove it. But it still is a great improvement.
-
Good replacement item
Got one of these to try out on my rifle, fits well, actually stays put better than the original. I will buy a couple more for spares.
-
It makes a difference
I did not realize just how hard the bolt hit until I tried this. The noise difference alone is a good reason to replace the factory stop. If you use a suppressor, you will notes the differences even more. I've had it on my 10/22 for a good while now and it still looks like new.
-
Shock Block
Works great! Action is much quieter. Less viberation. Part seems alittle stiffer than others I've used. That's a good thing. Must have for 10/22.
