"Companion" Magazine Bumper for Ruger 10/22
At a Glance:
- Easy to install with no permanent modifications to your magazines or firearm
- Comes with two bumpers
- Adds grip to bottom of rotary magazines for easy magazine seating and removal
These extended magazine bumpers for the Ruger® 10/22® 10-round rotary magazines are a must-have for anyone that knows how tricky removing the magazine can be.
Constructed of highly durable Zytel® and designed to work with standard 10-round Ruger® rotary magazines, the Companion Extended Magazine Bumper will provide years of enjoyable use. Stop struggling to remove the magazine and make gripping it easier with a two-pack of these competition grade magazine bumpers from TANDEMKROSS!
Please note: 10-round rotary magazines sold separately.
Don’t forget, all TANDEMKROSS products are made in the USA and come with a LIFETIME guarantee!
WARNING: This product can expose you to chemicals including cadmium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
138 Reviews
-
Should have purchased these a long time ago
These extensions cured the magazine challenge that often happens with the 10/22 and they were easy to install.
-
Magazine bumper for 10/22
I used the bumpers with a Ruger American rimfire that uses the 10/22 mag. It makes it so easy to put in or take out each mag.It also acts as a top if you like your hand back farther on the forgrip.Nice look to rifle.
-
Excellent Addition To Your Mags !
Just enough weight and additional area to grab on to, without getting in the way. Easy and simple install too. Would highly recommend this if you use the 10/22 factory 10 round mags.
-
Great Product
Love them.
-
Big Difference
These magazine bumpers make changing the 10-round magazines a snap. Easy to install, well priced, and well made makes it a great value in my book.
-
magazine bumper for Ruger 10/22
These were easy to install and work great. Glad I bought them.
-
Good, not great
It is very easy to strip the screws. The magazine is plastic and the screws are blunt.
-
Bumpers
Great product! I bought this mainly for my 9yr old son because he was having some difficulty inserting the mags. I think I ended up appreciating them more then him.
-
Magazine Bumper
Installed this item on my magazine and have had one range session with it. Works as advertised and is a great addition to my 10/22. I read some of the gripes prior to ordering but so far they seem wide of the mark. My guess is that lack of care in installation is the cause of some of the problems. Its not hard but after installing it I can see where sloppy threading of the screws could result in less than adequate attachment to the magazine. Holding everything tight and square while tightening each screw a little at a time until all were tight has so far worked well and resulted in a very solid attachment. My shooting partner was impressed with the part and since I only have 1 10-round mag, I gave him the other one. If you don't hear from me again, all continues to be satisfactory with this part. Nicely done Tandemkross.