"Twister" Takedown Knob for Ruger® 10/22® by Rim/Edge

Fits the standard model as well making for easy tightening and one less allen key in my kit

Another small upgrade to make life easier for you with your 10/22. Would recommend.

this works great but watch out. It is easy to over tighten this in synthetic stocks. I intended to us in in a Houge over molded stock but when tightened down it did not allow the bolt to operate fully. Also, the length is short on some of the Boyds laminate wood stocks, Will use it on another build though as the quality of the part is very good.

Makes cleaning so much easier more than worth it's weight in gold

Great quality product makes a easy takedown even more easy. Just a side note will not work in the Magpul X22 hunter stock.

Definitely a plus for any Ruger 10-22 owner. I have struggled in the past with both factory and aftermarket screws that were junk. This might appear to be expensive, but in the long run well worth the price. I'm using this on my KRG Bravo stock and have zero complaints. Action stays tight, no shift at all.

This is great unless u run a binary trigger from bf arms. You'll need an allen to remove the safety levers, rendering this less effective. I guess you'll go from 2 to 1 allen needed? Make a thumb screw for those and we'll have something.

I purchased two of the "Twister Take Down Knobs" to put the finishing touch on two custom 10/22 rifles I built from scratch with all new parts front to back for my grandsons. One with a Deluxe Walnut Mannlicher Stock 18.5 inch SS barrel, the other with a French Walnut Sporter stock and a 22 inch SS barrel. The Twister knob makes it much easier to adjust the tightness of the take down screw just right which from everything I have read can really affect the accuracy of the rifle.

thought this unit was abit unneeded but picked up a nice 10/22 that someone had really bogeyed up the fastener! got this twister unit as it has proven to indeed look good but make takedown easier too!