At a Glance:
- Torx head reduces risk of stripping head
- Replacement for damaged, stripped or lost factory screws
- Sold in a 4 pack!
Stripped a screw? Lost hardware? Don't let this stop your range day!
Save some time and and stock up on the replacement Torx Head Screw for Ruger® 10/22® Factory Picatinny Rails
These are an upgrade replacement to the factory hardware.
Product Specifications:
- #6-48 Thread
- .25 Thread Length
- T-10 Drive
PLEASE NOTE: Proper length screw must be used so that it doesn’t protrude on the inside of receiver and cause interference with bolt. Must have full thread engagement. Torque to Ruger® factory specifications
This product is protected against mechanical failure for life by TANDEMKROSS’s Lifetime Guarantee. Learn more about our warranty and returns policies here.
⚠️ WARNING: This product may expose you to chemicals including cadmium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.
4 Reviews
-
TORX HEAD SCREW FOR RUGER 10/22
Have had the flat head and dome headed blade type screws loosen on some of my 10/22's, more than once on two of them. Changing to the Torx Head screw has solved the problem as the torx screwdriver bit gets a good bite on the screw head and you get a good firm seat on the screw. Great Product. Highly Recommended. I just ordered 4 more sets.
-
10/22 Screws
These screws are better than factory due to factory slotted head stripping easily. Used these to install a picatinny so I could swap from day to night scope when switching from squirrel to coon hunting. Works great, just what I was looking for!
-
Rail Screws
Perfect 5 *****
-
Perfect fit
There should be a law. These screws should come with every rail for 10/22s! I
