At a Glance:
- Replaces original factory rear sight with open combat sight
- Fully adjustable for windage and elevation
- Provides improved visibility and faster sight acquisition
Set your sights on victory with the “Eagle Eye” Fiber Optic Rear Sight for the Ruger® PC Carbine™! Made of high grade aerospace aluminum, this fiber optic rear sight is an easy, drop-in replacement upgrade for the factory ghost ring sight.
The “Eagle Eye” is designed to complement the TANDEMKROSS Fiber Optic Front Sight for rapid target acquisition in all conditions. Installation is as easy as turning a single set screw. No permanent modifications or additional accessories are required!
Looking for a fiber optic front AND rear sight set? We have you covered! Check out the “Eagle Eye” Fiber Optic Sight Set for Ruger® PC Carbine™ here.
When installing your “Eagle Eye” Fiber Optic Rear Sight, ensure your sight is oriented as shown in the image below; with the hole for the set screw favoring the muzzle end of the rifle. When looking at its side profile, the rear sight should appear as though it is “leaning” towards the rear or stock end of the rifle.
The TANDEMKROSS fiber optic front and rear sights are designed to directly replace factory iron sights. This means they will only install on factory Ruger® PC Carbine models that come with iron sights from the factory (examples pictured below).
The Ruger® PC Charger™ and PC Carbine™ models with no iron sights from factory are NOT compatible with TANDEMKROSS fiber optic sight upgrades (examples pictured below).
Don’t forget, all TANDEMKROSS products are made in the USA and come with a LIFETIME guarantee!
WARNING: This product can expose you to chemicals including chromium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
12 Reviews
-
Sights
Absolutely love the new sights. What a difference from the stock peep sights. Great quality part.
-
tandemkross PC9 sights
Great sight picture once installed. As someone who worked in the fabricating industry I think it would be impossible to expect the Milling machines at Ruger and tandemkross to always be perfect. That said the rear sight initially would only slide on about 1/8 inch before binding up. The tolerances are very close. Just slow down, get some 600 grit paper and slowly do a little sanding at different spots. keep trying without force and a bit of lube. Remember it will take many small steps and then it will go on. There was no tandemkross label as in you tube video, but the orientation for which way to put it on is easy to see.. Once again-Great Sights!
-
Eagle Eye sight
Works as advertised. Not for very low or no light settings
-
EAGLE EYE SIGHTS
"EXSIGHTED" to receive my Eagle Eye sights today. Easy install, cant wait to get to the range to sight them in.
-
Highly visible sights
The TK rear w/ corresponding front sight offer a bright, easy to pick up sighting system. Compact, easy to install and cost effective. A viable alternative to an optic for those who value the simplicity and reliability of a standard sighting system.
-
Eagle eye sight.
The site is highly visible and works perfect with the green TK sight I installed. Would recommend.
-
Eagle eye fiber optic
Fiber optics to small, for varmint control, to expensive for what you get. You can purchase a Truglo red dot for that Amount of money105065791
-
Rear FO Sight
Purchased TK rear FO sight to have open pistol-like sight on my PCC9 instead of factory ghost ring. Well made, fair price and dead simple to install. Only negative is TK sight has shiny gloss black coating which reflects. After range session to confirm, will likely paint it matte black with rattle can. Don't prefer FO on sights anyway.
-
Kruger fiber optic rear sight
Works great.
