Ruger® PC Carbine™ "Eagle's Talon" Extractor Install Instructions
At a Glance:
- Highest Grade Tool Steel
- Designed for optimal impact and wear resistance
- Easily replaces factory part without any permanent modifications
The TANDEMKROSS “Eagle’s Talon” Extractor for Ruger® PC Carbine™ and PC Charger™ is a must-have upgrade. The “Eagle’s Talon” is made of hardened tool steel to outlast your factory extractor. Additionally, TANDEMKROSS’s precise manufacturing process and careful attention to detail ensure the extractor reliably and consistently grabs the empty cartridge to prevent failures to extract.
Whether in the heat of serious competition or while plinking for fun, malfunctions can easily ruin your day. Keep that from happening to you by making your good gun great with the “Eagle’s Talon” Extractor for Ruger® PC Carbine™ and PC Charger™ today!
Don’t forget, all TANDEMKROSS products are made in the USA and come with a LIFETIME guarantee!
WARNING: This product can expose you to chemicals including cadmium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov
19 Reviews
-
no extraction issues
I read that the original PC Carbine extractor had some issues over time. This one looks and feels much better than the original. I expect it'll last the lifetime of the rifle.
-
Eagles Talon Extractor
I have been having a great time with my pc charger right up to around 500 rounds. About three expended brass stove piped out of glock mags? I got to reading About the charger stove piping and was suggested to go to Tandemkross and get the whole kit they recommend. I did watched the video TANDEMKROSS has was very easy and now I'm up and running like the big boys . Stopped all the stove piping. You can hold the new and old parts in you're hand and really tell the difference. Well worth spending a little bit for a BIG change
-
Eagle Talon Extractor
I want to give a HUGE SHOUT OUT to Bill. Dude? Your installation videos are SOOOOOOO amazing, and so easy to follow. A few years ago I was a big skeptical about some of these parts and their installation. You (Bill) literally give the 'average' gun guy confidence with your installation vids. THANK YOU, THANK YOU, THANK YOU Bill, you're the best brutha.
-
Extractor
Very well made and slips right in. I like that you can see Tandemkross's name on the edge
-
PC Carbine Extractor
Much needed improvement for the Ruger PC Carbine. This extractor is well made and hopefully will fix the failure to extract problem on the PC. High quality part.
-
Eagle's Talon extractor
Quality USA made product.
-
review
Another addition to making my gun more reliable.
-
Eagle Talon extractor
I tried using my normal reloads in my Ruger PCC carbine and found they were a bit long and would not completely chamber and stick in the chamber, The stock extractor would not pull them out, I installed the Tandemkross extractor and tried it on a couple rounds and found it extracted them with no problem. The Eagle Talon extractor is well made, Easy to install and a great addition to the pcc.
-
Eagle's Talon Extractor
As with the rest of TandemKross's products, this one was simple to install,well finished and fairly priced. I haven't ran my carbine after the installation yet but I have no doubt that it'll improve reliability.
