Eagle's Talon Extractor Installation Instructions for the Browning Buck Mark
At a glance:
- Machined from hardened tool steel to increase longevity
- Sharp hook design grabs casings securely and surely
- Reduces failures-to-eject and stove-pipe malfunctions
The TANDEMKROSS Eagle's Talon Extractor for Browning® Buck Mark is a reliability upgrade that replaces the factory-provided Buck Mark extractor. The factory extractor often can’t maintain a secure enough hold on the spent casing as the pistol is cycling, causing stove-pipes and failures-to-eject malfunctions. TANDEMKROSS Eagle's Talon Extractor is CNC-machined with a positive hook that will grab and secure each round until it needs to be ejected.
While the factory extractor can chip, reducing its ability to consistently extract spent casings, the Eagle’s Talon extractor is machined from hardened tool steel for long-term strength and durability.
Eliminate your frustrations at the range and during speed shooting competitions with the Eagle's Talon Extractor for Browning® Buck Mark!
Supported Models:
- Browning® Buck Mark
- Browning® Buck Mark Rifle
⚠️ WARNING: This product can expose you to chemicals including cadmium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.76 Reviews
-
Mr.
Excellent product, I just polished the curve and sides of the claw to reduce friction against the slide. Very easy installation, 5 minutes.
-
Eagles extractor
With this extractor i am having problems,seams like in my case came a little bit biger than the original, and every time when firing the slide won't close all the way,and it won't fire. I endedup installing the original again.
-
mr
It works. Was having lots of stovepipes in my new Buckmark. This cured it. Runs like a sewing machine now. Too bad you have to spend extra to get your Browning or Ruger to run sometimes, but at least a new extractor is a relatively small expense
-
Eagle's Talon Extractor for Browning Buck Mark
The Eagle's Talon Extractor appears to be very well made. It was relatively easy to install and so far no extraction issues. Keep up the good work!
-
average guy
Buckmark was failing to extract, dropping spent cases causing stove pipes...total nightmare. Inspection showed the factory extractor didn't hold the case firmly and had zero tension as it could be tipped 0.050" before moving the plunger. Swapped in the tandemkross part, which took about 1 minute! Instantly could see it sat closer to the breech so the cases would be tighter. Also saw any motion of the extractor was resisted by the plunger. The hook is also sharper. Ran 30 rounds with 20 as fast as possible (0.15 splits) and had zero failures. Best 10 bucks you can spend to make a buckmark reliable.
-
Owner of My gun guy
quality made product, a little polishing and customer gun was ready to rock and roll
-
Great Product
Installed the extractor in my Browni g Buck Mark. Installation was easy and the product worked as advertised.
-
Works great
Very well made part. No more stuck cases or stove piping
-
FtEj No More!
I was getting 10% ftej on my stock Buck Mark. Cleanliness made no difference. Installed the Eagle's Talon and I've had one in hundreds of rounds. Miraculous!
