- Eliminates pesky C-clip
- Simplifies maintenance and disassembly
- Polished stainless steel for smooth cycling
62 Reviews
-
Buckmark recoil guide rod.
Excellent quality guide rod to eliminate the end keeper.
-
Recoil guide rod
I ve installed and used the guide rod in my browning 22. I put around 150 rounds through the browsing with the new guide rod. No jams all went smooth. Best part or now so best part was the break down for cleaning. I really liked the small hole to hold the spring back in order to remove the guide rod. Two thumps up
-
Eliminator Recoil Spring Guide Rod
It's a little longer than the original rod and only requires a few strokes on a file for an easy fit. Pistol cycles better and takedown is simpler for cleaning.
-
Browning Buckmark
So much better than factory recoil guide rod with flimsy clip. Simple to install & take out for cleaning.
-
Works Great
Installed in my pre-2000 model with no fitting problems. No sanding or filing. If you have an older model, like mine, installation shown in the video isn't quite the same but close enough to get it done. Didn't realize the OEM Rod looked as bad as it did until I installed this nice polished stainless one.
-
Recoil guide rod
As I was taking the stock rod out to replace it with this, the tiny C-clip took off for parts unknown. Confirmed that I had made the right choice. A few file strokes on the end of the rod and it fit perfectly. Much easier to install than stock.
-
Guide rod for BuckMark
To sum it up quickly. I purchased one for my first Browning BuckMark. I've now purchased two more for my other BuckMarks. For my personal use these are great. In my personal experience this is a huge improvement over the original Browning part.
-
Nice piece
I haven t shot with it yet, but it s a very nice piece, and does seem to cycle a little smoother.
-
Shadow mount
Went right in. Works great