TANDEMKROSS Victory Trigger Installation Instructions for the SW22
At a glance:
- Flat-faced, skeletonized design for better control and feel
- Textured trigger face offers a no-slip grip in any condition
- 100% adjustable for pre-travel and post-travel
- Can drop trigger pull weight up to ½ a pound
The factory Smith & Wesson® SW22 Victory® trigger stands out in the rimfire market for its crisp feel and light trigger pull. But even good triggers can be made GREAT! The TANDEMKROSS Victory Trigger for the Smith & Wesson® SW22 Victory® is the ultimate trigger upgrade, ideal for speed shooting competitors!
The TANDEMKROSS Victory Trigger removes nearly all pre-travel upon installation, and comes with pre- and post-travel adjustment screws to allow each shooter customize their S&W® SW22 VICTORY® trigger upgrade.
The skeletonized, lightweight design of the TANDEMKROSS Victory trigger provides a flat face that allows the shooter to pull straight back and makes it easier to tell if they are pulling too far to the left or right. In addition to actually reducing the trigger pull weight by up to .5lbs, the flat-faced design also allows the operator to place their finger lower on the trigger, increasing leverage and giving the perception of an even lower pull weight.
The textured trigger provides a no-slip surface regardless of speed or weather and allows for short, repeatable, identical trigger pulls. The trigger is made from aircraft-grade aluminum to be lightweight and durable.
The TANDEMKROSS Victory Trigger for SW22 Victory® is one of the best SW22® upgrades for competition shooters. Get yours today and take a giant step closer to VICTORY!
Want to make installs and maintenance easier? Give yourself a hand with the Magazine Vise Block for .22LR Platforms today!
427 Reviews
-
S&W trigger
Fast shipping on this product and a good fit.
-
Victory Green
Man this thing Rocks! Installation instructions was spot on.
-
Mr
Work fantastic. ..The video on install very helpful.
-
Not As Easy as Video
It did not want to go in as easily as portrayed. Took it to a gunsmith and he spent two hours fitting it. Was disappointed as it cost another $50 to install it.
-
Mr.
Good video for installing the TK trigger. I did run into quite a bit of frustration with the hammer locking in the fully cocked position. After several complete disassembly and reassembly exercises I called Tandemkross. Eric was great and explained that some of the SW Victory frames vary a little. What was happening was that my trigger was not moving far enough forward to reset. He suggested filing a small amount ( I filed about 1/16 inch) off of the trigger where it meets the frame. He also said if I screwed up the trigger don't worry as Tandemkross would replace it since they are the ones that suggested filing it. Works great now! Smooth and I don't have any wiggle side to side on the trigger as some have found with their installs. I had heard that a modified spacer is now being shipped so that is probably what I received. Installed the Halo slide handle and ordered the mag extenders. Impressed with the products. Another note now that I think of it: the disconnect bar retaining screw was slightly binding the disconnect bar if screwed down all the way. Backed off just enough to allow the trigger to move freely forward from the spring pressure but where the bar is still held in place.?
-
A Must Have Trigger
Don't let this one slip by you, Great trigger Best up grade you can give you S&W Victory.
-
Trigger Inprovement
My trigger pull went from 4.5 lbs. to 2.25 lbs. Substantial improvement over the factory trigger. My kit was slightly different than the one shown on the You Tube video. The spring and detent that provide the trigger return can be a challenge to install. I put masking tape of the frame and that stopped the spring from flying on my various attempts to install. Excellent product.
-
Ms
Nice
-
Do it!
Bestb$40 you can spend on a victory. Easy to instsll