Victory Trigger for Browning® Buck Mark

Victory Trigger for Browning® Buck Mark

TANDEMKROSS

$49.99
(158 reviews) Write a Review
SKU:
TK12N0108BLK1
Weight:
0.30 Ounces
Adding to cart… The item has been added

At a glance:

  • Flat, textured faced for better control and feel
  • 100% adjustable for overtravel
  • Lightweight skeletonized design
The trigger of any firearm is critical and must give the shooter as much control as possible. The sleek, skeletonized, and lightweight design of the TANDEMKROSS Victory trigger provides a flat face that many shooting pros prefer as opposed to the traditional curved triggers commonly seen in the Browning® Buck Mark market. This design allows the shooter to pull straight back - instantly providing the operator with the ability to tell if they are pulling too far to the left or the right.
 
The flat faced design also allows the operator to place their finger lower down on the trigger, increasing leverage and enabling them to take full advantage of lower trigger pull weights. The wide face distributes the weight of the trigger pull which also results in a perception of a lower pull weight. The textured trigger face provides a no slip surface regardless of speed, weather or shooting experience. This allows repeatable, near identical trigger pull movements. Coupled with the provided over-travel fine adjustment screws, this TANDEMKROSS exclusive trigger will bring any competitor a giant step closer to VICTORY!
 
Simplify firearm maintenance and installations with the Magazine Vise Block for .22LR Platforms!
 
This product is protected against mechanical failure for life by TANDEMKROSS’s Lifetime Guarantee. Learn more about our warranty and returns policies here.
⚠️ WARNING: This product can expose you to chemicals including chromium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.

158 Reviews

  • 5
    Great Trigger

    Posted by Zachary on 13th Feb 2021

    This is a great trigger. Feels great. Easy to install. The checking on the front makes for a super positive feel

  • 5
    Victory trigger

    Posted by Dennis Peat on 23rd Jan 2021

    Love it! Installed in older Buckmark with pre install trigger pull of 3 lbs 7 oz, brought trigger pull down to 2 lbs 9 oz, then installed gear box reduced sear spring to get final pull of 2 lbs 6 oz. Install was easy for both parts but took a minute for me figure out the New trigger pin orientation, blue locktite. Reduced pull and trigger results in crisp/ clean response. Very happy with these products

  • 5
    Perfectly Awesome!

    Posted by Ty Collet on 20th Jan 2021

    I have no words! This trigger is the best I’ve ever laid hands on. Installation was easy!

  • 4
    Sharp Edges

    Posted by Francis Klaskov on 6th Jan 2021

    Easy to change and I love to feel of the flat face textured trigger. Seen immediate results on 25 ft targets. The only drawback was after 30 rounds the edge of the trigger was beginning to hurt my finger. I took some sandpaper to round the edfe off. Much better. For that she gets 4 stars

  • 5
    buckmark trigger

    Posted by larryt on 3rd Jan 2021

    Excellent product as advertised. Installation very easy following the video.

  • 5
    trigger pull weight

    Posted by William Brickenstein on 30th Dec 2020

    Weight with Gearbox 1Lb, 14+/-2 ounces seven pulls on Wheeler digital(may be even more consistent, it's hard to pull on exactly the same spot on the trigger each time and stay straight back along frame). Adjusting overtravel is of necessity tedious, I was tempted to drill and access hole through the front of the trigger guard for a long allen wrench (still only took 2 - 3 minutes). You could sell a set of snap caps, but fired cases might work if loaded one at a time. Included was a silver pin not shown in the video, looked like it could quickly set upper trigger pin depth if a little shorter (shoulder left it sticking above frame on my early, no magazine safety model).

  • 5
    Victory trigger - Buckmark

    Posted by Scott on 27th Dec 2020

    I've been to the twice with the trigger. I had the play too tight on my first outing. This trigger is a big improvement over the factory model. More crisp on the break. It did need some oil to get it to reset quickly. There is definitely a run-in period. Installetion was easy, just have the video going when installing. Totally recommend.

  • 5
    The best trigger

    Posted by Andrei Bratz on 17th Dec 2020

    My browning Buckmark was very good whit a trigger spring upgrade, but whith the Victory Trigger, now it is amazing!!!! The best upgrade!

  • 5
    Victory Trigger

    Posted by Joe H on 21st Nov 2020

    I installed the Victory trigger on my Buck Mark at the same time I installed the Gearbox sear spring. My trigger pull weight went from 3 3/4 to 4 lbs to 2 -2 1/8 lbs. Even better than I had hoped! I also like that I can place my trigger finger down lower on the flat face trigger than I was able to on the factory trigger. Overall totally impressed and satisfied.

!