Victory Trigger for Browning® Buck Mark

TANDEMKROSS

$49.99
(144 reviews) Write a Review
SKU:
TK12N0108BLK1
Weight:
0.30 Ounces
Adding to cart… The item has been added
 
 
At a glance:
  • Flat, textured faced for better control and feel
  • 100% adjustable for overtravel
  • Lightweight skeletonized design
 
The trigger of any firearm is critical and must give the shooter as much control as possible. The sleek, skeletonized, and lightweight design of the TANDEMKROSS Victory trigger provides a flat face that many shooting pros prefer as opposed to the traditional curved triggers commonly seen in the Browning Buck Mark market. This design allows the shooter to pull straight back - instantly providing the operator with the ability to tell if they are pulling too far to the left or the right.
 
The flat faced design also allows the operator to place their finger lower down on the trigger, increasing leverage and enabling them to take full advantage of lower trigger pull weights. The wide face distributes the weight of the trigger pull which also results in a perception of a lower pull weight. The textured trigger face provides a no slip surface regardless of speed, weather or shooting experience. This allows repeatable, near identical trigger pull movements. Coupled with the provided over-travel fine adjustment screws, this TANDEMKROSS exclusive trigger will bring any competitor a giant step closer to VICTORY!
 
Simplify firearm maintenance and installations with the Magazine Vise Block for .22LR Platforms!
 
*Fits all Buck Mark models including the Buck Mark Rifle
 
Don't forget, all TANDEMKROSS products are Made in the USA and come with a LIFETIME guarantee!

WARNING: This product can expose you to chemicals including chromium, which is known to the State of California to cause cancer. For more information go to www.P65Warnings.ca.gov.

144 Reviews

  • 5
    Worthwhile improvement.

    Posted by Tom B. on 25th Aug 2016

    Installed in combination with an after market hammer in a Buck Mark used for falling plates. Less trigger travel, combined with a crisper reset, allowed faster plate runs. The installation is difficult due to the design of the Buck Mark, not the replacement parts. Good videos online will get you through, but it's not an easy installation. The improvement in trigger travel was immediately noticeable after installation.

  • 5
    Great trigger for the buckmark with some work

    Posted by Austin Elbert on 9th Aug 2016

    Purchased 2 victory triggers with serrated faces for my Buckmarks. They install with ease but did require some file work, specifically on the top where the front "tang" extends above the trigger inside the trigger guard. This surface had to be filed down in order for the trigger to reset. I actually came to like this because it allowed me to create a stop for the trigger which greatly reduced take up. Once both triggers were adjusted, I took them to the range and it feels like a brand new trigger job. Zero take up, post travel screw works flawlessly and the result is 2 pistols I love. Tandemkross, expect to see these at the 2017 Sportsman's Team Challenge Nationals!

  • 4
    Great trigger, needs fitting

    Posted by Freeman on 30th Jul 2016

    I have purchased two of the Victory triggers for my Buck Marks. One it dropped into with no fitting. My older Buck Mark required some fitting, but both have produced great trigger pulls of right at 2#.

  • 5
    Mr.

    Posted by Gary Taylor on 16th Jul 2016

    Tandemkross makes high quality aftermarket parts and upgrades. This trigger is no exception. Easy to install (Brian does excellent videos on installation process). It really made a difference on my accuracy.

  • 5
    Club Manager

    Posted by Chris Dover on 11th Jul 2016

    These triggers are excellent in just about every way. The one minor issue that I have is the location of the stop screw. I feel it is located in a spot that could bind on the curve of the trigger guard and would have been better suited higher up in the trigger. That said, it does not affect my opinion on the quality, ease of installation or results obtained from use. I do have a comparison video on my YouTube channel CloverTac where we compare this Victory trigger with a Volquartsen at a close up camera angle. Thanks Tandemkross, excellent product! Our shooters love them.

  • 5
    Victory Trigger and Base pads

    Posted by Tom Bagwell on 7th Jul 2016

    I have used the Victory Trigger and the Buck mark extended base pads and enjoy them very much. The Victory trigger sets out farther than the buck mark trigger and that allows me to get a better finger placement for better trigger control. The extended base pads helps when your on the clock and doing mag changes on the go, haven't had one mag not seated after installing the pads, there a must. Had a problem with the trigger after the install (all my fault) I used the strongest blue locktite known to man and ruined the trigger stop screw getting it back out, called tandemkross, not a problem they had 3 new screws to me in a couple of days (fast) all back together and working great, love all the Tandemkross products that I use and recommend there parts to everyone!!

  • 5
    Great part

    Posted by Ricardo on 7th Jul 2016

    This is a very easy install. Gives my gun a custom look at an affordable price.

  • 4
    Review

    Posted by Tom Seasor on 4th Jul 2016

    I have been using the Victory trigger for a short time, it has improved my shooting with the aspect that it has moved my finger placement forward and thus currying the problem of my finger sticking past the trigger and interfering with off hand placement.

  • 5
    Victory Trigger

    Posted by Art on 2nd Jul 2016

    The installation video made this a breeze to install. I really like the flat trigger it just seems to give me more control. Thanks Tandemkross for a great product.