Don't forget, all TANDEMKROSS MKIII™ series bushings come with a LIFETIME guarantee!
Steel Hammer Bushing for Mark III and 22/45 Pistols
- Magazines will slip right out
- Easier takedown and cleaning
- Can reduce failure to feeds
- Comes with colored installation instructions
This high quality 304 stainless steel bushing is made for high duty cycle shooting and replaces the Ruger® factory bushing allowing you to safely remove the magazine disconnect from the firearm. There are instructions on the internet showing the use of washers and other parts, but this is unreliable and unsafe! Use an actual part that is designed for the job. This bushing lets the hammer move properly and at the correct speed. You will be pleased with the fit and final result with this bushing. If you know how to clean this gun you can easily remove the disconnect. Removing the disconnect allows the magazines to fall free, allows them to seat properly and does allow the gun to fire with the magazine out for tactical competition and self-defense scenarios. Check to see if your state requires the magazine disconnect installed if the firearm is ever resold.
Supported Model List:MKIII™ -ALL MODELS!
- MKIII™ 22/45™
- MKIII™ 22/45™ Competition
- MKIII™ 22/45™ Government Target
- MKIII™ 22/45™ Target
- MKIII™ Competition
- MKIII™ Government Target
- MKIII™ Target
- MKIII™ LITE
- MKIII™ Hunter
*** ATTN: FAQ: Will this bushing work in my Volquartsen Hammer? YES. The bushing and VQ hammer will work together. However, it can be a tight fit to get them together. Please let us know if you are experiencing trouble and we will get you a bushing that will fit into the tighter VQ hammer.
Ruger® and its associated model names are registered trademarks of the Ruger® Corporation.
648 Reviews
-
Mr.
This product works just as advertised. I upgraded three Mark III's with this bushing in less than an hour. The bushing comes polished and ready to install. A very nice upgrade to the Ruger.
-
Mr.
Mags drop cleanly no more pulling them out
-
owner
this bushing is high quality. my magazine release actually works now!
-
Faster Reloads!!!
When I was shooting competitions, one of the things that could make or break a run was reload speed. With the stock bushing, and the magazine disconnect, it was impossible to get fast reloads. The magazines would simply drop 1/8th of an inch instead of falling out of the magwell. Made the swap in 5 minutes, and now empty mags will drop to the floor and my reloads are much smoother!
-
Mag disconnect Bushing
I ordered this before I decided to buy the "Majestic Arms Speed Strip" kit. I installed it with no problems before I went to the range. It's amazing how much it improves the magazine ejection, one push & falls out now. Later that day I installed the Speed Strip kit, bushing works great (I was concerned if it might not work with the new hammer), perfect fit, going back this. I weekend to shot again
-
Made a huge difference.
Have not had a malfunction since I installed this. Really makes seating the mag easy. No more problems with the mag not fully seating causing malfunctions.
-
Mr.
Fast shipping, very well made, easy installation and worked as advertised.
-
Owner
Very pleased
-
Mechanic
Turns your mkIII into the magazine launching, positive eject pistol it always should have been.
